How to Set Up Your Behringer UM2 Audio Interface on Windows 10

If you're looking to get started with recording music or podcasting using your Behringer UM2 audio interface and Windows 10, there are a few key steps you'll need to follow. The first step is to install the necessary driver software developed by Behringer.

Once the driver is installed, turn on your monitor speakers and adjust the volume dial on your interface until you can comfortably hear your audio. Next, plug your headphones into your interface's headphone port and turn down the volume to minimum.

To connect your powered monitor speakers to your audio interface using audio cables, make sure they are switched off before connecting them to the outputs on your interface. If you're using a USB hub, it's recommended that you directly connect your interface to your computer if possible.

In order to reduce latency in your recording process, you'll want to adjust the buffer size on your audio interface. This can be set in powers of two starting at 32 samples. A good compromise is to use either 256 or 512 as your buffer size, but keep in mind that a lower buffer size will result in less latency, but also increased CPU load.

In Ableton Live, you'll need to activate the inputs and outputs that you need, and only activate the ones you need to save CPU. You can also choose separate devices for both input and output on macOS, or deactivate one of them if needed.

Finally, make sure your audio interface is connected to your computer using a USB cable, and that any available software drivers are downloaded and installed, making sure they are up to date and supported on your operating system. With these steps complete, you'll be ready to start recording with your Behringer UM2 audio interface on Windows 10.

Behringer um2 drivers windows 10